| Knowledgebase Home | Contact |
 Search the Knowledgebase |
 Browse by Category |
| How can I attach motors to the NXT with the fewest number of pieces? | |||
1. Two Motor Car: Materials i. 9-holed beams (3) ii. 7-holed beams (2) iii. NXT motors (2) iv. Assortment of friction pins Attach the back of the two motors together (above the wire input) using a 9-hole beam 
Attach Motors on both sides at front to NXT using 7-holed beams  Attach Motors on both sides at back to NXT using 9-holed beams and extended pins  Final Car! 
2. One Motor Car Materials i. 9-holed beams (2) ii. NXT motor iii. 8-stud axle iv. 10-stud axle v. 12-stud axle vi. Short axle holders (2)  vii. Long axle holders (2)  viii. Assortment of friction pins and bushings Attach one short axle holder in the middle hole on both sides of the base of the NXT at the front.  Place motor on bottom of NXT between axle holders and place 8 stud axle through the axle holder and the back hole of the motor.  Attach one long axle holder in the outside hole on both sides of the base of the NXT, place a 10 stud beam through the axle holder and the second hole in the motor, secure with small bushings  Attach 9-holed beams to both sides of NXT at back. Put 12-stud axle through both beams and the middle hole in front of the motor and secure with bushings  |
Print this page
Email this page
Post a comment
| Visitor Comments |
| No visitor comments posted. Post a comment |
| Related Questions |
| No related questions were found. |
| Attachments |
| No attachments were found. |